Programmable 4 Stage Lean Out, Data Logger and Digital Display all in one!

Featuring the MoTeC SDL - check out the base features

Fuel Control - turn solenoids on based on timer, speed or other input to logger. Up to 4 stages can be used to linearize the fuel curve of your mechanical injection system. By changing the amount of fuel delivered to the engine you can maintain a proper air fuel ratio as the engine rpm varies. You can also control the fuel curve based on other inputs to the SDL such as Gear. Outputs can trigger solenoids directly and also trigger timing retards or can be separated into any combination of timing retards and solenoid controls using the 4 outputs.

Sensor Measurement Channels - Engine RPM, Throttle Position, Manifold Air Temperature, Barometric Pressure, Boost, Input Shaft Speed, Driveshaft Speed, Ground Speed, Transbrake or Clutch input, Actual Ignition advance, Lateral and Vertical G, Fuel Pressure, Oil Pressure, Air Fuel Left and Air Fuel Right, Battery Voltage, Display Temperature, Gear and the Timer. Additional 3 Temperatures available.

Data Logging Capabilities - All above channels are logged at 200 times per second allowing 14.5 minutes of logging before being overwritten. Logging Start and Stop conditions are user definable or can be triggered externally if desired. Additional Channels can be logged as desired from 1 to 200 times per second.

Display Capabilities - Display can be adjusted as required using the SDL Manager software. Display can be customized to suit the users requirements. Backlit Display available on any kit - must be specified at time of ordering

Warning alarms - Customizable driver warning alarms display when a problem arises based on a sensor input. Base alarms are fuel pressure and oil pressure

Data Analysis Software - I2 or optional I2 Pro Analysis software.

Weight - .95 lbs.

Cost  See Table Below